Optional deregistrationOptional healthHealth check parameters for this target group.
Optional nameNot used. Supply the name you want for a TargetGroup through the [name] constructor arg.
The port to use to connect with the target. Valid values are either ports 1-65536, or
traffic-port. Defaults to traffic-port.
The protocol to use to connect with the target.
Optional proxyBoolean to enable / disable support for proxy protocol v2 on Network Load Balancers. See doc for more information.
Optional slowThe amount time for targets to warm up before the load balancer sends them a full share of requests. The range is 30-900 seconds or 0 to disable. The default value is 0 seconds.
Optional stickinessA Stickiness block. Stickiness blocks are documented below. stickiness is only valid if
used with Load Balancers of type Application
Optional tagsA mapping of tags to assign to the resource.
Optional targetAn existing aws.lb.TargetGroup to use for this awsx.lb.TargetGroup. If not provided, one will be created.
Optional targetThe type of target that you must specify when registering targets with this target group. The
possible values are instance (targets are specified by instance ID) or ip (targets are
specified by IP address) or lambda (targets are specified by lambda arn). The default is
ip. Note that you can't specify targets for a target group using both instance IDs
and IP addresses. If the target type is ip, specify IP addresses from the subnets of the
virtual private cloud (VPC) for the target group, the RFC 1918 range (10.0.0.0/8,
172.16.0.0/12, and 192.168.0.0/16), and the RFC 6598 range (100.64.0.0/10). You can't specify
publicly routable IP addresses.
The vpc for this target group.
Generated using TypeDoc
The amount time for Elastic Load Balancing to wait before changing the state of a deregistering target from draining to unused. The range is 0-3600 seconds. The default value is 300 seconds.